CME + CUE integration

My environment:  CME and CUE 7.0


CUE can be configured to integrate with CME and UCM, in this post I will give you an example on how to create integration between CME and CUE.  Make sure you have the correct license, as integrating with CME and UCM requires different licenses.


Sample Configuration for CME+CUE integration

On CME side

interface in1/0

     ip unnumbered gi0/0.502

     service-module ip address 1.2.3.253 255.255.255.0

     service-module ip default-gateway 1.2.3.254

ip route 1.2.3.253 255.255.255.255 in1/0

dial-peer voice 4050 voip

     destination-pattern 4050

     session protocol sipv2

     session target ipv4:1.2.3.253

     dtmf-relay sip-notify

     codec g711ulaw

     no vad

telephony-service

     voicemail 4050

ephone-dn 11

     call-forward busy 4050

     call-forward noan 4050 time 10

ephone 14

     number 8000....

     mwi on

ephone 15

     number 8001....

     mwi off

On CUE side

ccn application voicemail

     max session 4

ccn trigger sip phonenumber 4050

     application voicemail

     enabled

     maxsession 4

Done!  You can try to either call in the voicemail pilot or press the envelop button see if you can hear the prompt.  Next step is to create the user in CUE then you can leave a message.

Some other commands that you will find it useful during the integration.

Factory Reset CUE

On CUE

offline

restore factory default

Other commands

CME:     service-module in1/0 session

CUE:     show software license

CUE:     software install clean url ftp://1.2.3.4/xxx.pkg